Perform the following steps to get the Tunnel Client set up for the first time, after installation. If you chose to install and start the service during the installation, you should not have to perform steps 6 or 7.

1. Run the Manager
2. Select the Manage | Properties menu
3. Set the Target Properties for the Tunnel Server you are going to connect to:
   • Enter a Target Host Address
   • Enter a Client Login name
   • Enter a Client Password
   • The standard SSH Port for the Tunnel Server is 22
   • Choose an Encrytion method
   • Leave Compression at this stage
4. Add an Incoming Port
   • Click the Add button to add a new incoming port
   • Leave the default parameters for now (Protocol:UDP, Port:514)
   • Leave the Client Properties at the defaults for now
5. Click the Ok button to save the settings
6. Select the Manage | Service Install menu item
   (You should receive a message indicating the install was successful)
7. Select the Manage | Service Start menu item
   (The Service should start running)
8. Check the various panels of the Manager to ensure they reflect your settings and that no errors have occurred

You can now set up the Tunnel Server:

Perform the following steps to get the Tunnel Server set up for the first time, after installation. If you chose to install and start the service during the installation, you should not have to perform steps 7 or 8.

1. Run the Manager
2. Select the Manage | Properties menu
3. Set the Service Properties for the Tunnel Server Service
   • They should match your Target Properties setup for the Tunnel Client
   • The standard SSH Port for the Tunnel Server is 22
   • Leave the other Service Properties for now
4. Add an Outgoing Port
   • Click the Add button to add a new outgoing port
   • Set the parameters to point to a Kiwi Syslog you want to send the data to
5. Click the Ok button to save the settings
6. Select the Manage | Clients menu item
   • Add a Login and Password for an incoming client connection
   • These should match what was set for the Tunnel Client that is to connect with this Tunnel Server
   • Click the Ok button to save the setiings
7. Select the Manage | Service Install menu item
   (You should receive a message indicating the install was successful)
8. Select the Manage | Service Start menu item
   (The Service should start running)
9. Check the various panels of the Manager to ensure they reflect your settings and that no errors have occurred

If the Tunnel Client has been set up and run previously, there should now be a connection with the Tunnel Server.