Server Setup

Previous  Top  Next

Perform the following steps to get the Tunnel Server set up for the first time after installation. If you chose to install and start the service during the installation, you should not have to perform steps 7 or 8.

1.

Run the Manager

2.

Select Manage / Properties menu item

3.

Set the Service Properties for the Tunnel Server Service

They should match your Target Properties setup for the Tunnel Client

The standard Port for the Tunnel Server is 22

Leave the other Service Properties for now

4.

Add an Outgoing Port

Click the Add button to add a new outgoing port

Set the parameters to point to a Kiwi Syslog you want to send the data to

5.

Click the Ok button to save the settings

6.

Select Manage / Clients menu item

Add a Login and Password for an incoming client connection.

These should match what was set for the Tunnel Client that is to connect with this Tunnel Server.

Click the Ok button to save the settings

7.

Select Manage / Service Install menu item

You should receive a message indicating the install was successful

8.

Select Manage / Service Start menu item

The Service should start running

9.

Check the various panels of the Manager to ensure they reflect your settings and that no errors have occurred

If the Tunnel Client has been set up and run previously, there should now be a connection with the Tunnel Server.