|
Client Setup
|
Previous Top Next |
| Perform the following steps to get the Tunnel Client set up for the first time after installation. If you chose to install and start the service during the installation, you should not have to perform steps 6 or 7.
|
| 1. | Run the Manager
|
|
|
| 2. | Select Manage / Properties menu item
|
|
|
| 3. | Set the Target Properties for the Tunnel Server you are going to connect to.
|
| Fill in a Target Host Address
|
| Fill in a Client Login name
|
| Fill in a Client Password
|
| The standard Port for the Tunnel Server is 22
|
| Choose an encryption method
|
| Leave compression for now ***
|
|
|
| 4. | Add an Incoming Port
|
| Click the Add button to add a new incoming port
|
| Leave the default parameters for now - UDP on port 514
|
| Leave the Client Properties at the defaults for now
|
|
|
| 5. | Click the Ok button to save the settings
|
|
|
| 6. | Select Manage / Service Install menu item
|
| You should receive a message indicating the install was successful
|
|
|
| 7. | Select Manage / Service Start menu item
|
| The Service should start running
|
|
|
| 8. | Check the various panels of the Manager to ensure they reflect your settings and that no errors have occurred.
|
|
|
| You can now set up the Tunnel Server.
|
| *** This feature is only available in the licensed version
|